I'm just throwing around ideas right now. In the front corners I could either bolt through a piece of 4x4 to lock them together or maybe some sort of latch for easier disassembly, less space and lighter weight. 3 Apply dielectric grease to the sockets of any incandescent light fixtures to stave off corrosion. 2 Keep a can of color-matched paint or cold galvanizing spray on hand and coat over scratches, chips and rust spots as soon as you notice them. Carriage bolts through the plywood and the uprights on the existing rail. 1 Rinse your trailer with fresh water after every use and periodically wash it with soap and water. I'm thinking maybe for the sides, I could have two 8' lengths 16-20" high, connected by hinges to hold them together and so I can fold it up when not in use. They already have holes that I can bolt to. The uprights on the rails are about 10" high. The runabout was a light, inexpensive, open car with basic bodywork and no windshield, top, or doors. So I'm thinking about using 3/4" plywood and make it 16-20" high. How to build a classic mahogany runabout outboard boat. RMB46E18 A close-up of the yacht ensign flying from the stern of an antique Gar Wood runabout. Save up to 30 when you upgrade to an image pack. I had at one time considered using 2x12s to make a 24" high wall all around, but not only is that a fair amount of weight, but seems like I probably don't need to go a full 24" high. Find the perfect vintage runabout boat stock photo, image, vector, illustration or 360 image. It'll probably be more like 5000# max once I factor in the weight of the walls, and I'd rather not max out the trailer either.Īnyway I'm debating how I should go about this. It's a 7000# trailer and it weighs 1740#, so theoretically I can have about 5250# of payload. Let people know what youre interested in finding and. Looking at weights of a cord of wood, seems like there's no point in going too high with the walls. As with lovers of mahogany runabouts, wooden canoe enthusiasts are pretty well connected with each other. They need to be fairly easily removable as for most of my uses I wouldn't want them on it. I have a 16' landscape utility trailer and I'm looking at building some short walls for it so I can use it to haul firewood.
0 Comments
Leave a Reply. |